When transmitting the used to switch the RPM of the helicopter's head. mixture curve data from the transmitter to the governor, the Up to 3 rates can be set for each condition. Page 166 Tap to the rate item . * In order to use the Governor function of the T18SZ, it is necessary to change the settings on the governor for the low Adjust the trim Also, according to the manual, the cable is directional - i.e. one end of the cable is the instructor end and thus the physical connection will determine which device will function as the instructor. If the cable is reversed, and the instructor's Tx has Trainer function enabled, the student device will not power on. I also set my flaps up like this: Set travel and subtrims to zero. Set switch to mid flap position (middle position on switch) Make sure servo is centered and physically adjust the flaps linkages to get 50% flaps. Then use end point on each channel to adjust zero and full flap positions. Remote Control FUTABA 7C-2.4GHZ Instruction Manual. 7-channel fasst radio control system for airplanes/helicopters (86 pages) Remote Control FUTABA 7PX User Manual. 2.4ghz system t-fhss sr (192 pages) Remote Control FUTABA 7XC Instruction Manual. (194 pages) Remote Control FUTABA 10CAG Instruction Manual. Set up your Triple Rates and Exponential the quick and easy way with step-by-step instructions from World-Champion pilot Chip Hyde. And if you already have any Futaba 2.4GHz receivers you are in the luck, the 4GRS sup- ports Futaba HSS, S-FHSS and T-FHSS technology. THE GOODS. The Futaba 4GRS is set up in your typical twin stick fashion, with the throttle control on the left and the steering handled by the right stick. The throttle stick can be set up in various ways. Thank you for purchasing a Futaba FHSS 3PL 2.4GHz system. This system is based on the combination of the newly developed 2.4GHz transmitter and its corresponding receiver. Before using your 3PL 2.4GHz system, read this manual carefully and use your R/C set safely. After reading this manual, store it in a safe place. FHSS 3PL 2.4GHz system 2. If you are using a Futaba transmitter, please note that some Futaba transmitters have the throttle set to reversed by default. Leave reversing set to defaults to start, and reverse as needed. 3. Aileron, Elevator, and Rudder should NOT be Reversed, other channels may be reversed at users preference 4. fY5Ae4.

how to set up futaba transmitter